Marathon MAGNUM ROUTER Betreibershandbuch PDF herunterladen (Seite 40)

4. Check for proper inflation of the trailer tires. For maximum tire pressures, refer to Specifications beginning on

page 10.

5. Check the wheel lugs. Tighten or replace any that are loose or missing. If a tire

has been removed for axle service or replaced, tighten the lugs in the order shown

to the following specifications:

A. Start all lug nuts by hand.

B. First pass tighten to 20-25 ft-lbs (27-33 Nm).

C. Second pass tighten to 50-60 ft-lbs (67-81 Nm).

D. Third pass tighten to 90-120 ft-lbs (122-162 Nm).

Note: After the first road use, re-torque the lug nuts in sequence.

6. Maximum recommended speed for highway towing is 45 mph (72 km/h). Recom-

mended off-road towing speed is not to exceed 10 mph (16 km/h) or less, depending on terrain.

LIFTING THE UNIT

A central lift point is located on the top of the unit. The

central lift point is connected to a lift structure inside the

unit. Attach a sling or hook directly to the central lift point

only if the devices are in good condition and the equip-

ment being used to raise the unit has sufficient capacity.

For approximate weights, refer to Specifications begin-

ning on page 10. Always remain aware of others around

you when moving or lifting the unit. Keep the doors closed

and locked.

DAILY WALK AROUND INSPECTION

Look for conditions that could hinder performance or safety, such as (but not limited to) oil/coolant/fuel leakage,

blocked vents, loose/missing hardware, and electrical connections.

Visually inspect the fan belt for cracks, fraying, stretching, and verify the belt is properly seated in the pulley grooves.

Replace the belt according to the manufacturer’s recommendations.

Note: At the 500 hour/12 month service interval, it is recommended that the belt be removed and checked for wear.

While the belt is removed, inspect pulleys and bearings. Rotate and feel for hard turning or unusual sounds. If pulleys

or bearings need replacement, contact the engine manuafacturer.

Failure to perform a daily inspection may result in serious damage to the prime mover.

GENERAL MAINTENANCE

Poorly maintained equipment can become a safety hazard. In order for the equipment to operate safely and properly

over a long period of time, periodic maintenance and occasional repairs are necessary. NEVER perform routine

service (oil/filter changes, cleaning, etc.) unless all electrical components are shut off. Before servicing the unit,

always follow the instructions listed below.

• Verify the Control Power switch is turned to the OFF (O) position.

• Verify the circuit breakers are open, the OFF (O) position.

• Activate (push in) the emergency stop switch.

• Disconnect the negative (-) terminal on the battery.

• Attach a “Do Not Start” sign to the control panel. This will notify everyone that the unit is being serviced and

will reduce the chance of someone inadvertently trying to start the unit.

• Never wash the unit with a high pressure hose or with any kind of power washer.

00204

Central Lift Point

00419

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Marathon MAGNUM ROUTER Betreibershandbuch Seite 40

Kommentare zu diesen Handbüchern