Marathon MAGNUM ROUTER Betreibershandbuch PDF herunterladen (Seite 28)

GENERATOR OUTPUT CONNECTION LUGS

The unit is equipped with connection lugs, located on the lower portion of the control box behind the lug box door.

The lugs provide connection points for attachment of external loads to the generator. A large decal on the inside of

the connection lug door details the proper connections for selected voltages.

WARNING

It is HIGHLY RECOMMENDED that only a trained and licensed electrician perform any

wiring and related connections to the generator. Installation should be in compliance

with the National Electrical Code (NEC), state and local regulations. Failure to follow

proper installation requirements may result in equipment or property damage, per-

sonal injury, or death.

WARNING

Before any connections are made to the generator, make sure that the main circuit

breaker and the Control Power switch are in the OFF (O) position. Potentially lethal

voltages may be present at the generator connection lugs.

DANGER

IMPROPER OR INCORRECT CONNECTIONS TO A BUILDING’S ELECTRICAL SYSTEM

CAN CAUSE POTENTIALLY LETHAL VOLTAGES TO BACKFEED INTO UTILITY LINES.

THIS MAY RESULT IN INJURY OR ELECTROCUTION TO UTILITY WORKERS NEARBY.

MAKE SURE THE GENERATOR IS SUPPLYING POWER TO AN ISOLATED OBJECT

OR BUILDING THAT IS NOT CONNECTED TO ANY UTILITY LINES.

Connections to the lugs should be made by running the power cables up through the

opening in the bottom of the box. DO NOT make any connections directly to the lugs

without routing the cables through the slot. Use a hex-wrench to tighten the cable

connections. The connection lug door is equipped with safety interlock switches that

will trip the main circuit breaker and disable the voltage regulator, if the door is opened

while the unit is operating.

WARNING

Never attempt to disable or modify the lug door safety

switches. Equipment damage, personal injury or death

may result.

A ground connection is located next to the connection lugs. The unit MUST be

connected to a good earthen ground for proper operating safety. The generator neutral

is bonded to ground when it is shipped from the factory. The bonding plate will need

to be removed when the generator is used as a standby power source. INSTALLATION

SHOULD BE IN COMPLIANCE WITH THE NATIONAL ELECTRICAL CODE (NEC),

STATE AND LOCAL REGULATIONS.

GENERATOR CAM LOCK CONNECTION(S) OPTION

The unit may be equipped with cam lock connections located below the receptacles. These receptacles provide

connection points for the attachment of external loads to the generator. A decal below the cam lock connections

details the proper connections for selected voltages.

WARNING

It is HIGHLY RECOMMENDED that only a trained and licensed electrician perform any

wiring and related connections to the generator. Installation should be in compliance

with the National Electrical Code (NEC), state and local regulations. Failure to follow

proper installation requirements may result in equipment or property damage, per-

sonal injury or death.

RUN CABLES THROUGH

OPENING IN BOTTOM

OF LUG BOX

00450

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Marathon MAGNUM ROUTER Betreibershandbuch Seite 28

Kommentare zu diesen Handbüchern